Installation Sheet

5
© 2019 Monte Carlo Fan Company
4/2019
13 14 15
16
17 18
Install the bottom plate of light fixture.
Align the holes on bottom plate with the
screw holes on the bars and install the
bottom plate with decorative set screws
provided.
Helpful hint: Make small adjustment by
moving the bars a little may help to align
the holes with screw holes.
Install a 8W LED lamp.
Caution: Use LED lamp only.
Caution: Do not replace bulb until it
cools down.
Flip the fan assembly over and carefully
place it on Styrofoam.
Note: Handle it carefully to avoid damaging
or bending the light fixture.
Remove preassembled keeper pin and
cross pin from downrod.
Partially loosen downrod set screws from
yoke at top of motor assembly.
Place downrod over canopy, canopy
bottom cap and yoke cover.
Keeper pin
Cross pin
Downrod
Canopy
Downrod
Yoke cover
Canopy bottom
cap
Lamp
Decorative
set screw
Bottom
plate