Installation Sheet

4
© 2019 Monte Carlo Fan Company
4/2019
7 8 9
10 11 12
Place light fixture assembly over the lead
wires and attach it onto the plate on
motor, aligning the keyhole slots on the
top plate of light fixture with the
preassembled screws on the plate. Twist
clockwise till lock.
Reinstall the screw removed in step 6.
Tighten all screws securely.
Caution: Handle it carefully to avoid
getting hurt from the tip of the bars.
Loosen 2 and remove 1 preassembled
screw from the top plate of light fixture.
Save screw for later use.
Connect white wire from fan to white wire
from socket assembly and then connect
blue (or black) wire from fan to blue (or
black) wire from socket assembly.
Install the socket assembly onto light
fixture. Align the keyhole slots on the
socket assembly with the preassembled
screws on the light fixture. Twist
clockwise till lock.
Reinstall the screw removed in step 9.
Tighten all screws securely.
Caution: Tuck the lead wires into the
plate on socket assembly as shown in
inset and make sure the light lead wires
are not pinched between the light pan and
the LED light fixture.
Attach glass by locating dimples in top
plate of light fixture with grooves on the
glass and twist clockwise until tight.
1
2
Light fixture
Caution
Caution
Caution
Caution
Caution
2
Socket
assembly
Glass