Installation Sheet

3
© 2019 Monte Carlo Fan Company
4/2019
1 2 3
4 5 6
ON
OFF
ON
OFF
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Use AC 120V/60HZ power supply
only.
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35 lbs).
Before attaching fan to outlet box, ensure
the outlet box is securely fastened by at
least two points to a structural ceiling
member (a loose box will cause the fan to
wobble). Remove the two outlet box
screws provided with the box, aligning
the holes of the mounting bracket with
the holes of the outlet box. Reinstall the 2
outlet box screws securely.
Install the bars with the top plate of light
fixture using set screws provided.
Note: the end with bend should be
upward, and the indent outward.
Place motor assembly on a suitable area
of Styrofoam and install the blade
brackets with set screws provided.
Tighten screws securely.
Note: Carefully handle it and do not
damage the lead wires from motor.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Mounting bracket
Set screw
Blade bracket
Bar
top plate
Set screw
This side up
Indent
Plate on motor