Instructions / Assembly

19
Lift Conopy allowing the 2 studs to
protrude through the canopy.
Install knurled nuts and tighten the
knurled nuts securely. The canopy
should adjust for any irregularity in
the ceiling or outlet box.
21
L o o s e n 2 a n d r e m o v e 1
preassembled scews from the
plate on motor. Save screw for
later use.
22
Attach light pan on to the plate on
motor, aligning the keyhole slots
with the preassembled screws on
the plate. Twist clockwise till lock.
Install the screw removed in step
21. Tighten all screws securely.
28
25
Attach light fixture onto light pan,
aligning the keyhole slots on the
light xture with the screws on light
pan and twist clockwise till tight.
Install the screw removed in step
26. Tighten all screws securely.
Install scroll by aligning the
set screw and pop it onto the
blanking plate with the light
pan. Repeat this process for
remaining scrolls.
24
Attach blanking plate onto light
pan, align its holes on top side
area with the screw holes on the
side of ligt pan and re-install the 4
set screws removed in step 23.
20
Insert blade into the slot on ywheel and install blade screws, ber washers
and enhance plate aligning each of the holes as shown. Repeat this process for
remaining blades.
Note: Make sure the side with a label “This side up” is installed upward.
Enhance plate
27
Connect white wire from fan to
white wire from light fixture, then
connect the black wire from fan to
the black wire from light xture.
26
23
L o o s e n 2 a n d r e m o v e 1
preassembled screw from light
pan. Save screw for later use.
Re mo v e 4 pr e a s se m b l ed
screws from side of the light
pan. Keep screws for later
use.
For fan without light, go
to step 23
For fan with light, go to
step 26