Owner’s Manual UL Model No.
Installation saFeTy TIps warnInG: TO reduce The rIsK OF FIre, elecTrIc shOcK, Or InJury TO persOns, OBserve The FOllOwInG: read and save These InsTrucTIOns 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
8 7 9 Safety cable installation Safety Cable Lag Screw Lag Screw Safety Cable Washer Lock Washer Tighten the 2 Set screws on the Yoke once the downrod is in place.Check motor for shipping stabilizers and remove if present. Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball.
19 20 21 Place canopy over fan body aligning holes. Replace the 3 screws removed and tighten securely. Check motor for shipping stabilizers and remove if present. Take 4 screws from hardware pack and insert 2, one on each side of bracket to match the L slot screw holes in canopy. Keep 2 screws for later use. Remove the all thread studs from the lower part of the mounting bracket.
TROUBLE SHOOTING If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
