Installation Sheet

5
© 2014 Monte Carlo Fan Company
1/5/2014
13 14 15
16 17 18
Insert the short blade into the lower
couplers and then insert the long blade
into upper couplers on the hubs. Repeat
this process for the remaining blades
assemblies on the other side of the hubs.
Note: Make sure the screw holes in blade
frames are installed upward.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Place light pan over the lead wires and
attach it onto the plate on motor.
Align the keyhole slots on the light pan
with the preassembled screws on the
plate on motor. Twist clockwise till lock.
Reinstall the screw removed in step 15.
Tighten all screws securely.
Remove 3 preassembled screw from the
light pan. Save screws for later use.
Connect white wire from fan to white wire
from LED light fixture and then connect
black (or blue) wire from fan to blue (or
black) wire from LED light fixture.
Attach LED light fixture onto the light pan,
aligning the holes on the LED light kit with
the screw holes on light pan. Reinstall the
screws removed in step 17. Tighten all
screws securely.
Caution: Tuck the lead wires into the
plate on socket assembly as shown in
inset and make sure the light lead wires
are not pinched between the light pan and
the LED light fixture.
Align the screws holes in blade frame and
the holes in the coupler and then fix the
blades in the couplers with set screws
provided.
Long blade
Short blade
Lower coupler
Upper coupler
Light pan
13
Screw holes
Plate on motor
LED light fixture