Installation Sheet

5
© 2019 Monte Carlo Fan Company
1/2019
13 14 15
1716
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Place the lead wires from fan over the
central hole of light pan.
Aligning the keyhole slots on the light pan
with the preassembled screws on the
plate. Twist clockwise till lock. Reinstall
the screw which was just removed.
Tighten all screws securely.
Connect white wire from fan to white wire
from LED light fixture and then connect
blue (or black) wire from fan to black (or
blue) wire from LED light fixture. Be sure
plugs connection clasped together firmly.
Attach LED light fixture onto the light pan,
aligning the keyhole slots on the LED light
fixture with the preassembled screws on
the light pan. Twist clockwise till lock.
Reinstall the screw which was just
removed. Tighten all screws securely.
Note: If you don’t want to install the fan
with LED light, go to step 17 for blanking
plate installation.
Only apply to the
items with blanking plate.
Attach glass by locating dimples in light
pan with grooves on the glass and twist
clockwise until tight.
Only apply to the items with blanking
plate
Isolate the quick connects with electrical
tape.
Attach blanking plate by locating dimples
in light pan with grooves on the blanking
plate and twist clockwise until tight.
Note: Do not install LED light fixture if
use blanking plate.
Loosen 2 and remove 1 preassembled
screw from light pan. Save screw for later
use.
Plate on motor
Light pan
LED light fixture
Install LED Light Fixture
Glass
Blanking plate
Install Blanking Plate