Installation Guide

6
© 2015 Monte Carlo Fan Company
3/23/2015
Remote Controller Operation
Remove the battery cover from the remote control transmitter and install
battery. Replace the cover. This remote uses 12V battery, Duracell MN21 /
Evereday A23 / GP 23A all 12V.
Note: If not using for long periods of time, remove battery to prevent
damage to remote transmitter, and store the remote transmitter away from
excess heat or humidity
Set/change the dip switch position on the transmitter to desired code
setting. If you have more than one fan in your house and you don't want them
to be controlled by the same transmitter, you will need to change the position
of the dip switches.
Remote Control Setting (Learn function) and Speed Setting
1.Restore power to your fan, press and hold the “SET” button for at least 5
seconds. You must press the ‘SET” button with in 60 seconds of restoring
power to the fan.
Note : If the fan is installed with light (down light), light will twinkle twice then
off. The remote control setting process is complete and your fan is ready for
use. For fans without light, check operation using remote transmitter.
Note : If the power is on already, you must turn the power off, and then turn
the power back for remote control setting.
12V BATTERY
The buttons on the remote control transmitter control the fan speed and light as follows.
Fan speed
Ⅰ= minimum speed Ⅱ= low speed
Ⅲ= medium low speed Ⅳ= medium speed
Ⅴ= medium high speed Ⅵ= high speed
■ This button turns the fan off.
Forward/Reverse button- This button is to control direction of fan rotation. Press once
to change direction of the fan rotation. Fan must be running to reverse.
Light button- Press this button quickly to turn light on or off. To dim light, hold down the
button, the light will cycle from bright to dim to bright until button is released.
Note : This remote controller has auto resume function, the fan and light will maintain the
last setting if turned off.
Note : Clunk sound may be heard while the fan is being turned on/off, or forward/reverse.
Dip switch
“Set”
Battery cover
SET
This device complies with part 15 of
the FCC rules.Operation is subject
to the following two conditions.
(1)This device may not cause
harmful interference and(2)This
device must accept any interference
received,Including interference that
may cause undesired operation.
Model:RH787T
FCC ID:CHQRH787T
SET
This device complies with part 15 of
the FCC rules.Operation is subject
to the following two conditions.
(1)This device may not cause
harmful interference and(2)This
device must accept any interference
received,Including interference that
may cause undesired operation.
Model:RH787T
FCC ID:CHQRH787T