Instructions / Assembly

7/1/2013
© 2013 Monte Carlo Fan Company
7
36
Connect white wire from fan to
white wire from light fixture and
then connect black wire from fan to
black wire from light xture.
37
Attach light xture on to light pan,
aligning the keyhole slots on the
light xture with the screws on light
pan and twist clockwise till tight.
Install the screw removed in step
35. Tighten all screws securely.
38
Install 100-watt JDE 11 base bulb. Bulb
included. WARNING: Over lamping the
fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed.Reset the lights by turning
off, replace bulbs with the correct
wattage bulbs, turn the power on.
Note: Do not replace bulb until it cools
down.
39
Attach glass to light pan by
locating dimples in light pan
with grooves in glass and twist
clockwise until tight.
40
Remove battery cover. Install 12V battery
into wall remote. Duracell MN21 / Eveready
A23 / GP 23A all 12V.Attach cover of remote
by placing over buttons and snap the battery
cover in place.
41
Place face plate over battery compartment
and buttons. Place remote over 2 pins on front
cover. Attach cover of remote by placing over
4 pins and snapping into place.
HAND HELD INSTALL
42
Install wall control unit to outlet box
using machine screws provided.
43
Attach front cover to wall control
with screws provided. Snap battery
cover in place.
WALL MOUNT INSTALL
44
Reverse feature of this fan is controlled
by a switch located on top of the fan
body. Turn off the fan and wait until fan
blades come to stop. Setting the reverse
switch in the left hand side will result in
downrod airow and setting the switch in
the right hand side will result in upward
airow.
Reverse
switch