Instructions / Assembly

7/1/2013
© 2013 Monte Carlo Fan Company
6
27
Install remote receiver into the
mounting bracket.
28
Make wiring connections as indicated above.
White from fan to white from remote marked
N. Blue from fan to blue from remote marked
light. Black from fan to Black from remote
marked L. White from house to white from
remote marked AC N . Black from house to
Black from remote marked AC L. Connect all
green ground wires to Grounded wire from
House.
29
Make wire connections to power source using
wire nuts provided. Make sure that no laments
are outside of the wire nut. After making the wire
connections, the wires should be spread apart
with the grounded conductor and the equipment-
grounding conductor on one side of the outlet
box and ungrounded conductor on the other side
of the outlet box. The splices after being made
should be turned upward and pushed carefully up
into the outlet box.
Supply
circuit
31
Install blade bracket with blade by 3
blade screws and washers provided.
Tighten securely. Repeat this
process for remaining blades. Note:
Make sure the side with a label “This
side up” is installed upward.
33
32
Loosen 2 and remove 1
preassembled scews from the
plate on motor. Save screw for
later use.
Install the blade assembly to motor
using the pre-installed screws.
Tighten screws securely. Repeat
this process for remaining blade
assemblies.
34
35
Attach light pan on to the plate on
motor, aligning the keyhole slots
with the preassembled screws on
the plate. Twist clockwise till lock.
Install the screw removed in step
33. Tighten all screws securely.
Loosen 2 and remove 1
preassembled screw from light
pan. Save screw for later use.
30
Lift fan to mounting bracket,
aligning the “L” shape holes with the
screws on the mounting bracket.
Turn the fan clockwise to lock in
position. Install the other 2 canopy
mounting screws provided and
tighten all screws securely.