Instructions / Assembly

7/1/2013
© 2013 Monte Carlo Fan Company
5
21
Pass lead wires and safety cable
through canopy and then Place
the canopy over the yoke screws
aligning the large holes from the
canopy over the remaining screws
of the yoke.
24
Hang fan from mounting
bracket by the hands free
hook into a closed hole on
the edge of the Canopy.
22
Re-stall the 3 screws removed in
step 20.
Go to step 31 to nish
installation
19
Lift Conopy allowing the 2 studs to
protrude through the canopy.
Next lift the cover ring and install
knurled nuts as shown. Tighten the
knurled nuts securely. The canopy
should adjust for any irregularity in
the ceiling or outlet box.
Hand free
hook
20
Remove side covers from canopy
Remove set screws and pins from
yoke as shown in inset.
Remove every other screws from yoke
on top of motor housing as shown.
Save screws for later use.
Flushmount Installation
23
Partially install 2 of the screws (screws
provided) to the side panel of mounting
bracket corresponding to the open
slotted holes on the canopy upper rim.
Remove the studs from the lower part of
the mounting bracket.
26
Set dip switches on the Remote Transmitter
and Remote Receiver to the same settings.
This must be done so the units will
communicate properly. If you have other fans
you can set to control from one transmitter
by setting both receivers the same as the
transmitter. If you have more than one fan
with remote. You can set the dip switches to
different positions to have separate control.
Remote transmitter dip switch
Remote receiver dip switch
For Canadian installation and for USA fan and light
kit combinations over 35 lbs, in both flush and
downrod mode the safety cable must be installed
into the house structure beams using the 3” lag
screws,washers, and lock washers. provided. Make
sure that when the safety cable is fully extended
the leadwires are longer than the cable and no
stress is placed on the leadwires.
Note
: If Installing The Secondary Support Safety
Cable in the U.S., Do Not Remove Knockouts In The
Outlet Box.
25
Lag screw
Safety cable
Washer
Lock washer
Lag screw
Safety cable
Safety cable installation