Instructions / Assembly

5
© 2014 Monte Carlo Fan Company
1/5/2014
13 14 15
16 17 18
Insert the short blade into the lower
couplers and then insert the long blade
into upper couplers on the hubs. Repeat
this process for the remaining blades
assemblies on the other side of the hubs.
Note: Make sure the screw holes in blade
frames are installed upward.
Loosen 2 and remove 1 preassembled
set screws from light pan. Save screw for
later use.
Connect white wire from fan to white wire
from light fixture. Then connect black wire
from fan to black wire from light fixture.
Attach the light fixture onto the light pan ,
aligning its keyhole slots with the
preassembled set screws on the light pan
and twist clockwise till lock. Reinstall the
screw removed in step 15. Tighten all
screws securely.
Install a G9 75 watt halogen bulb, bulb
included.
Caution: Do not replace bulb until it
cools down.
WARNING: Over lamping the fan will result
in the fan lights shutting down until the
proper wattage of bulbs are installed.
Reset the lights by turning off the wall
switch, breaker,or by remote. Replace
bulbs with the correct wattage bulbs, turn
the power on.
Align the screws holes in blade frame and
the holes in the coupler and then fix the
blades in the couplers with set screws
provided.
Long blade
Short blade
Lower coupler
Upper coupler
Light pan
Light fixture
Bulb
13
Screw holes