Installation Sheet

ManualsBrandsMonte Carlo ManualsCeiling FansMinimalist Max 72 in. LED Indoor/Outdoor Aged Pewter Ceiling Fan with Light Grey Weathered Oak Blades

11/1/2014

SET

Dip(Code) Switches

Set code switch

Remote Transmitter

REMOTE CONTROL SETTING and OPERATION

Press the button to get desired fan speed, Low to High.

Press the button to get desired fan speed, High to Low.

Press the OFF button to turn fan off.

Press this forward/reverse button to get desired airﬂow

direction. Fan must be running to reverse. It will take about 25

seconds for fan to slow down and change rotation direction.

Press this button quickly to turn light on or off. To dim light, hold

down the button, the light will cycle from bright to dim to bright

until button is released.

Note: Fan speed and Light will maintain last setting if turned off

by a wall switch.

The buttons on the remote control transmitter control the fan speed and light

as follows. (Fig. 4)

Down Speed

Turn Fan Off

LED Indicator

Fan/R

UP Speed

Light ON/OFF

& Dimmer

Remote Transmitter

Universal Mode and Learning Mode

There are “Universal Mode” and “Learning Mode” with the remote controller.

If choosing “Universal Mode”, simply place both dip (code) switch at UPPER

position. Your fan with the remote controller is ready to use. (Fig. 3)

Note: If using universal mode, your fan can be controlled with other remote

transmitters with the same setting.

To control the fan with speciﬁc remote transmitter, choose “Learning Mode” by

placing the dip (code) switch at LOWER position and then make learn function

setting as below.

Make “Learn function setting” at the position within 5 meter distance from the

fan. Restore power source to your fan, press and hold the “SET” button for about

4 seconds until buzzer inside receiver sounds. Your remote controller is ready to

operate the fan. You must press the “SET” button within 1 minute of restoring

power to the fan. (Fig.3)

Note: If the power is on already, you must turn the power off for at least 5

seconds and then turn the power back for remote control learn function setting.

The buzzer inside receiver will sound for about 4 seconds after turn the power

back and then it is ready for learning function setting. If the fan is running after turn

power back, still wait for at least 5 seconds and then press and hold the “SET”

button for about 4 seconds until buzzer inside receiver sounds. Your remote

controller is ready to operate the fan.

Battery cover

Fig.3

Fig.4

Upper position

Lower position