Installation Guide

4
© 2013 Monte Carlo Fan Company
11/15/2013
7 8 9
10 11 12
Connect the lead wires and thread safety
cable from motor assembly through
downrod.
Helpful hint: For making it easier to insert
cross pin through downrod yoke and
downrod in the next installation step,
Carefully insert a phillips screwdriver through
yoke and downrod (don’t damage the lead
wires) as a guide and then push the cross
pin and pull the screwdriver in the mean time
as shown in above inset.
Slip downrod into motor housing yoke,
aligning holes and install cross pin and
keeper pin. Insert cross pin through yoke
and downrod until point appears on the other
side, and insert keeper pin on cross pin.
Pull the downrod up tight against the cross
pin, and then evenly tighten the downrod set
screws on motor housing yoke.
Warning: Cross pin and keeper pin must be
installed securely, failure to install them will
result in serious injury.
Place column over downrod and put it in
position by aligning the recessions with
the set screws on top side of housing.
Place canopy ring and canopy over
downrod with column. Handle it carefully
to avoid damage from scratch.
Install ball end of downrod into mounting
bracket opening. To slip hanger ball
into mounting bracket by slanting fan
assembly for about 35 degree as
shown in above illustration.
Align (engage) slot on ball with tab on
mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
Connect the safety cable from fan to the
Ceiling support cable.
Slide cable clamp onto the safety cable
from fan. Place the end of cable through
the loop of ceiling support cable and then
feed end of cable into clamp hole and
firmly tighten set screw. Cut off excess
safety cable.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Column
Canopy
ring
Column
Column
Cover
Set screw
Attach Safety
Cable to Ceiling
Support Cable
Tab
Keeper pin
Cross pin
Yoke
Canopy
Column cover
Downrod
Safety cable from fan
Canopy
Canopy ring
Downrod/Hanger
Ball Assembly
Fan wires
Fan Wiring
Light wires
Yoke
Safety
cable
Cable clamp
Set screw
Outlet Box
Hanger Bracket
Hanger ball
Hanger
Bracket
Setscrew
Tab
Slot
Philips
screwdriver
Cross
pin