Installation Sheet

5
© 2017 Monte Carlo Fan Company
3/2017
13
14 15 16
Make wiring connections using wire connectors provided as indicated above.
Red from fan to Red from remote marked Motor U.
Purple from fan to Purple from remote marked Motor V.
Brown from fan to Brown from remote marked Motor W.
White from fan (Light) to White from remote marked For Light.
Blue from fan (Light) to Blue from remote marked For Light.
White (Neutral) from house to White from remote marked AC IN N.
Black (Live) from house to Black from remote marked AC IN L.
Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Insert the remote receiver into mounting bracket.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the other side of the outlet box. The splices after being made should be turned upward and
pushed carefully up into the outlet box.
Raise canopy to mounting bracket, aligning
loosened screws in mounting bracket with
slotted holes in canopy. Twist canopy
clockwise to lock. Reinstall screws (with
washers) that were previously removed in step
3 and then tighten all screw securely
Install canopy ring onto canopy by aligning the
grooves in canopy ring with the humps on
canopy and snap it onto canopy.
Connect the light lead wires from fan to
LED light kit with a quick connector as
shown in the illustration.
Note: Be sure quick connector clasped
together completely.
Place light lead wires in the hub and
attach LED light kit onto the hub by
locating ridges in the hub with grooves in
the LED light kit and twist clockwise until
tight (Refer to installation step 17).
Caution: Make sure the lead wires are
placed in the hub and keep them from
damage.
Green From Hanger Ball
Green From Mounting Bracket
Receiver
White- AC IN N
Black- AC IN L
Green or Bare Ground
Wall Switch
120V Supply
(Power Supply)
Motor U- Red
Motor V- Purple Motor W- Brown
To Motor U- Red
To Motor V- Purple
To Motor W- Brown
Black (Live)
White (Neutral)
Light - White
Light - Blue
To Light - White
To Light - Blue
LED light kit
Ridge
Hub
●
●
●
Hump
Groove
Canopy ring
Wires placed in
the hub
LED light kit
LED light kit