Installation Guide

5
© 2016 Monte Carlo Fan Company
11/2016
14
15 16
17
12 13
Lift canopy up, aligning its keyhole slot
with the preassembled screw on
mounting bracket and twist
counterclockwise to lock in place.
Reinstall the screw removed in step 11
and tighten all screws securely.
Attach canopy bottom cap onto canopy
by aligning its notch with the screws on
mounting bracket and twist clockwise till
tight.
Lift light pan up, thread the light lead
wires through the hole in light pan as
shown.
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light pan
with the preassembled screws on the
plate. Twist clockwise till lock.
Reinstall the screw removed in step 13.
Tighten all screws securely.
Remove 3 set screws from light pan.
Save screws.
Connect white wire from fan to white wire
from LED module and then connect blue
wire from fan to blue wire from LED
module.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Plate on motor
Light pan
Light lead
wires
LED module
Light pan