Instructions / Assembly

4
© 2013 Monte Carlo Fan Company
4/25/2013
7 8 9
10 11 12
Make wiring connections using wire
connectors provided as indicated above.
White from house to White from remote
receiver marked AC N. Black from house
to Black from remote marked AC L.
Connect all green grounded wires to
Grounded wire from House. Make sure
that no filaments are outside of the wire
connector.
Lift motor assembly, aligning the keyhole
slots with the preassembled screws on
mounting plate, and twist clockwise till
lock. Reinstall the screws removed in
step 4. Tighten all screws securely.
Loosen 2 screws across from each other
and remove the other 2 preassembled
screws from side of mounting plate
(corresponding to installation step 10).
Save screws for later use.
Attach housing onto mounting plate,
aligning the keyhole slots on the housing
with the screws on mounting plate and
twist clockwise till tight. Reinstall the
screw removed in step 9. Tighten all
screws securely.
Install blade with screws provided,
aligning each of the holes as shown and
tighten all screws securely. Repeat this
process for remaining blades.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Receiver
Capacitor
Driver
Ground/Green
White
Wall
switch
Black
Power
source
Housing
Blade
Plate on motor