Installation Guide

4
© 2015 Monte Carlo Fan Company
10/25/2015
7 8 9
10 11 12
After making the wire connections, the wires
should be spread apart with the grounded
conductor and the equipment-grounding
conductor on one side of the outlet box and
ungrounded conductor on the other side of
the outlet box. The splices after being made
should be turned upward and pushed carefully
up into the outlet box.
Loosen 2 screws across from each other
and remove the other 2 preassembled
screws from side of mounting plate
(corresponding to installation step 9).
Save screws for later use.
Lift motor assembly, aligning the keyhole
slots with the preassembled screws on
mounting plate, and twist clockwise till
lock. Reinstall the screws removed in
step 8. Tighten all screws securely.
Install blade with screws and washers
provided, aligning each of the holes as
shown and tighten all screws securely.
Repeat this process for remaining blades.
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
Attach light pan onto the plate on motor,
aligning the keyhole slots on the light
plate with the preassembled screws on
the plate. Twist clockwise till lock.
Reinstall the screw removed in step 11.
Tighten all screws securely.
Plate on motor
Grounded
wires
Ungrounded
wires
Blade
Light pan