Installation Guide

3
© 2016 Monte Carlo Fan Company
11/2016
1 2 3
4 5 6
ON
OFF
ON
OFF
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
Use AC 120V/60HZ power supply
only.
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 35 lbs.)
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 35 lbs).
Before attaching fan to outlet box, ensure
the outlet box is securely fastened by at
least two points to a structural ceiling
member (a loose box will cause the fan to
wobble). Remove the two outlet box
screws provided with the box, aligning
the holes of the mounting bracket with
the holes of the outlet box. Reinstall the 2
outlet box screws securely.
Put blades together, overlap edges of
blades one another and align the holes
each other and then assemble the blades
with wood screws provided. Do not over
tighten.
Note: For easy assembling and avoiding
blade damage from scratch, put blades
on Styrofoam as shown above.
Flick blade assembly over and place it on
motor.
Align the holes as shown in graphic and
install blade assembly onto motor with
set screws provided. Tighten set screws
securely. Do not over tighten.
Mounting bracket
Blade assembly
Motor
Wood screw
Blade
Top styrofoam