Owner`s manual

INSTALLATION OF LIGHTS

For designs with a single light kit.

First install the bulb. Do not tighten too much. Use 60 Watts bulbs maximum. Place the

globe on the light kit plate by hand-tightening the 3 wing screws. Do not tighten too

much or you might break the glass. Turn the main power back on. Installation is

finished.

For designs with fitters.

First place the glasses into the fitters by hand-tightening the 3 wing screws on each fit-

ter. Do not tighten too much or you might break the glass. Turn the main power back

on. Do not tighten. Use a 60 Watt bulb maximum per socket.

TROUBLESHOOTING

1. Check blue wire from fan to make sure it is connected to hot wire from house.

2. Check for loose or disconnected wires in fan switch housing.

3. Check for loose or disconnected wires in light kit.

4. Check for fault

y light bulbs.

WARNING: Over lamping the fan/light kit will result in the

fan/light kit lights shutting down until the proper wattage of bulbs

are installed. Reset the lights by turning off the wall switch, breaker,or by

remote. Replace bulbs with the correct wattage bulbs, turn the power on.

CAUTION: Make sure main power is turned off before entering switch housing.

Customer Service Center:

301 West Washington St.

Riverside, NJ 08075

1-800-519-4092