Owner`s manual

I
nstall glass bowl using rubber wash-
er and nut provided.
12
Install the switch housing cover with light
kit to the fan by screwing the three side
mount screws.
11
L
ocate blue and white wire from the fan
marked “for light kit”. Connect blue from fan to
b
lack from light kit and white from fan to white
from light kit by pushing connectors together.
Note: If your fan does not have plugs they may
b
e cut as shown on figure “B” on page 2.
10
Install finial nut and tighten.
14
13
Install finial cap to fitter body. Align
hole in fitter, glass and finial cap to
allow the fan speed pull chain to
pass through.