Owner`s manual

Remove the plug from the center of
the switch housing by unscrewing or
pushing out. This plug will no longer
be needed.
Tighen keeper nut onto threaded
pipe from the light kit.
Remove the switch housing cover
from the fan by unscrewing the three
side mount screws.
1
2
8
6
Install switch housing to light kit by
turning clockwise to tighten.
Install keeper nut over lead wires.
7
GENERAL INSTALLATION
Thread wires from light kit through
center hole in switch housing.
5
s
witch
housing
c
over
Tread wires from light kit through
center hole in reflector plate.
3
4
Install reflector plate to light kit by
turning clockwise to tighten.
9
Install 3 x 60 watt candelabra torpedo
shape bulbs. Bulbs included.
WARNING:
Over lamping the fan/light kit
will result in the fan/light kit
lights shutting down until the
proper wattage of bulbs are
installed. Reset the lights by turning
off the wall switch, breaker,or by
remote. Replace bulbs with the cor
-
rect wattage bulbs, turn the power
on.