Owner’s Guide and Installation Manual 3ACR52XXD Series Fan UL Model No. : AC-552 Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 8.25 kgs 18.
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVETHE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70-1999), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 4 Loosen 2 screws on yoke to allow down rod to slip into yoke. 7 Place yoke cover over downrod as shown.
10 11 12 Install keeper pin. Evenly tighten the 2 set screws on the yoke, once the down rod is in place. Make sure the studs protruding from the bottom of the Mounting bracket are installed with threads all the way through the bracket. 13 14 Safety cable installation 15 Remote transmitter dip switch Safety cable Lag screw Lag screw Safety cable Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight.
19 20 Lift Conopy allowing the 2 studs to protrude through the canopy. Install knurled nuts and tighten the knurled nuts securely. The canopy should adjust for any irregularity in the ceiling or outlet box. Install blade bracket with blade by 3 blade screws provided. Tighten securely. Repeat this process for remaining blades. 22 23 24 Loosen 2 and remove 1 preassembled scews from the plate on motor. Save screw for later use.
28 Attach glass to light pan by locating dimples in light pan with grooves in glass and twist clockwise until tight. 31 WALL MOUNT INSTALL Install wall control unit to outlet box using machine screws provided. © 2013 Monte Carlo Fan Company 29 30 Remove battery cover. Install 12V battery into wall remote. Duracell MN21 / Eveready A23 / GP 23A all 12V.Attach cover of remote by placing over buttons and snap the battery cover in place. Place face plate over battery compartment and buttons.
Remote Control Transmitter Features: MEDIUM SPEED LED LIGHT FAN REVERSE (Press once to change direction of the fan) Fan must be running to reverse. HIGH SPEED LOW SPEED LIGHT ON/OFF SETTING AND DIMMER (Press and hold to dim light infinitely) FA N O F F S E TT I N G (Turns fan off only) FAN SPEED Depress “1 dot” for low speed, “2 dots” for medium or “3 dots” for high. To turn fan off press square”. LIGHT DIMMER To turn light on, press light dimmer once quickly.
Trouble Shooting If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, please check this Trouble Shooting Chart. If a problem cannot be remedied, or you are experiencing difficulty in installation, please call our Customer Service Center at the number printed on your parts list insert sheet.
Feb.2012 New format Jul.
