Specifications

active, processor controlled, bi-amped speaker system W24A
Control and connection panel
9
ENGLISH
F
U
S
E
12
3
PUSH
5
1
2
3
4
7
6
1 The W24A speaker system is equipped with XLR male
(OUT) and female (IN) parallel connected sockets allowing
easier daisy-chaining.
❚ Mixer output ➔ W24A input ('IN' socket)
❚ W24A output ('OUT' socket) ➔ input ('IN' socket) of the
W24A to be connected in series.
☛ See 'connectors' and 'connection example' at pages
15 and 16.
2 Main volume (VOL). Adjusts the input levels of the two
built-in power amplifiers to adapt them to the output level
of the mixer.
3 High frequencies level control (H.F.).
N.B: if you are using a Montarbo mixer (or any mixer
having an output level of 0dB) for optimum performance
it is advisable to set both controls fully clockwise (to their
maximum settings).
4 Mains power switch (I/0).
5 Ground-lift (GND LIFT): this switch allows to lift signal
ground from chassis ground (but the chassis is still
connected to the safety ground). This allows to lower
annoying hums caused by 'ground loops' when more
units are connected.
6 Fuse holder with fuse.
7 Power supply socket with Power Con
®
connector.
☛ See 'wiring of the power cable for the Power Con
®
connector' at page 11.