Specifications

T12A / T15A active, bi-amped loudspeaker systems
1 IN: balanced input, fitted with a Neutrik Combo
®
connector which accepts both 3 pin XLR and jack plugs.
☛ See 'connectors' and 'connections' at pages
14 and 15, and 'applications at pages 16 and 17.
2 OUT: balanced output, (in parallel with the input), using a
3 pin XLR connector. It allows for easy parallel connection of
other T15A/T12A or active systems.
☛ See 'connectors' and 'connections' at pages
14 and 15, and 'applications at pages 16 and 17.
3 MASTER LEVEL: it is the master volume control.
Adjusts the input levels of the 2 built-in power amplifiers
to adapt them to the output level of the mixer.
It also allows to adjust the speaker volume when this system
is used in parallel with others.
Typical operating setting is at maximum position.
The trademark Neutrik Combo
®
is property of Neutrik
9
ENGLISH
4 H.F. - M.F. LEVEL: High frequencies level control.
Note: if you are using a Montarbo mixer (or any mixer
having an output level of 0dB), for optimum
performance it is advisable to set both the MASTER
LEVEL and the H.F. - M.F. LEVEL controls fully clockwise
(at their maximum settings).
5 POWER / 0 - I: Mains power on/off switch.
6 Mains power cord socket (with built-in fuse). Use only
the factory supplied mains cable or a suitable cable with
a ground connection and marked with the safety approvals
valid in the country of use.
7 Ground socket. It must be used only when the mains
cable is connected to an ungrounded socket, or if the socket
ground connection is unknown.
Control and connection panel
1
34
2
Service fuse
FUSE
REPLACEMENT
Spare fuse
5
6
7