Specifications

T12A / T15A active, bi-amped loudspeaker systems
Power supply connection:
• Make sure that the mains voltage corresponds to the
voltage indicated on the rear panel, under the mains socket.
• Use only the factory supplied mains cable or, if a
different plug style is needed, a suitable cable with
a ground connection and marked with the safety
approvals valid in the country of use.
Parallel connection of two or more systems:
• Always make sure to use only heavy gauge, high
quality SHIELDED cables.
Connect the first T15A/T12A’s LINK OUT to the second’s
LINK IN, the second’s LINK OUT to the third LINK IN,
and so on.
☛ See 'connection example' at page 15.
Connection to the mixer:
If the mixer has XLR balanced outputs: use standard balanced
XLR connectors.
If the mixer has XLR unbalanced outputs, unless you are
using a Montarbo mixer, make sure that the XLR outputs on
the mixer are unbalanced to IEC 268 standard:
1 = GND, 2 = HOT, 3 = GND.
If the mixer has JACK unbalanced outputs, use suitable Jack
to Jack cables or Jack to XLR adapters wired according to
IEC 268: pin 1=ground, pin 2= tip, pin 3=ground
☛ See 'connectors' at page 14.
• Always use only heavy gauge, high quality SHIELDED
cables (signal cables).
• Always make sure that the mixer and the powered
enclosures are switched off before connecting them.
This will to avoid annoying noises and signal peaks, which
can also be dangerous for the enclosures themselves.
Product care and maintenance:
• Do not expose the enclosure to heat sources (heaters or
other products that produce heat).
• Never expose the enclosure to direct sunlight, excessive
vibrations or mechanical shocks.
• Avoid operating and storing the enclosure in damp or
dusty places: this will avoid malfunctions or premature
degrading of specifications.
• Avoid using the enclosure close to strong sources
of electromagnetic interferences (e.g. video monitors,
high power electrical cabling).
This may lead to degradation of audio quality.
• Care should be taken so that objects do not fall and liquid
are not spilled into the enclosure. In public event don't let
people, musicians, technicians or anyone put glasses, cups,
ashtrays or cigarettes on the enclosure.
• Use a soft brush or a jet of air to clean the enclosure.
Do not use alcohol, solvents or detergents.
• Do not remove the protective grid.
• Take care of your connector cables. Make sure that they
are not damaged, knotted or twisted.
• Do not force connectors and controls.
• Make sure the mains power switch is off ('0') before
starting any connection.
Important !
10
ENGLISH