Instructions / Assembly
PLEASE NOTE: If you purchased your item “ready to nish” special care must be taken to properly apply a high
grade nal nish in a timely manner. Doing so will help protect your purchase from discoloration and damage
caused by exposure to ultra-violet light and/or weather. if the products intended use is outside, please use an
exterior rated nish to also protect from weather damage. See use and care instructions for further information.
Failure to adequately protect item by application and as needed, re-application of a nal nish may void warranty.
Hanging the Swing:
Step 1. Separate the two dierent lengths of chain and the “S” shaped hooks.
Step 2. Count eight links from the end of one long chain “G” and insert an “S” hook into the 8th link. Attach the
other end of this “S” hook into the header hardware pre-mounted at the factory.
Step 3. Count forty links from the opposite end of the long chain that is now hanging from the header and
insert another “S” hook into the 40th link.
Step 4. Attach one end of the short chain “H” to the remaining end of the “S” hook from the last step.
Step 5. Insert an “S” hook into the remaining end of the short chain.
Step 6. Counting nine links from the bottom of the long chain hanging from the header, insert “S” hook into the
9th link.
Step 7. Attach the opposite end of the “S” hook from last step into the eye bolt at the front/bottom of the swing
assembly.
Step 8. Insert the remaining end of the middle “S” hook (Step 5 Above) into the eye bolt at the swing back/top of
the swing assembly.
Step 9. Repeat steps 2 through 8 to hand the other side of the swing
*Adjust the height and balance of the swing by moving the “S” hooks one link at a time until satised