Instructions / Assembly

Assembly of the Swing Legs:
Step 1. Lay out the four frame legs (shown as “I” in the included image) and the side braces “J” into two assem-
blies similar to the letter A.
Step 2. Insert the two tenons of side braces “J” that you positioned in step 1 above, into the holes of the frame
legs “I”.
Step 3. Secure each side brace “J” with a 4” lag bolt and washer combination “N” by inserting 4” lag & washer
into pre-drilled hole in frame legs. Tighten halfway with a 1/2” wrench.
Step 4. Insert the end of the header “K” into the notched openings at the top of the swing legs “I”. Ensure the
eye bolts are turned downward toward the bottom of the legs. (e large end of the A shaped triangle)
Step 5. Secure the header “K” and swing legs “I” with the 6” hex bolts, washers and nuts supplied. Tighten half-
way with a 1/2” wrench.
Step 6. Repeat steps 3 through 5 for other leg assembly.
Step 7. With the help of an assistant, stand the completed swing leg assembly upright and carefully spread the
legs of the assembly so that it balances properly and all four legs rest on the oor.
Step 8. Completely tighten the 4” lags in the side braces “J”.
Step 9. Using a carpenter’s square, ensure the legs are perpendicular to the header. Completely tighten the 6”
bolts.
Attaching the Half Log Braces:
Step 1. Using a tape measure or yardstick, measure 14 1/2 inches in from the end of the header “K” and mark
the location. is is where the top end of the half log brace will be mounted.
Step 2. Drill a 3/16” hole approximately two inches deep and horizontal to the ground at the location you
marked in step 1, above.
Step 3. Attach the half log brace “L” to the header, inserting a 4” lag bolt with washer through the brace into the
hole you drilled in step 2, above.
Step 4. Move the lower half of the half log brace le and right until the factory drilled hole is centered over the
leg of the swing. Mark that location and drill a 3/16” hole approximately two inches deep. Secure this end of the
half log brace as you did the other end in step 3, above.
Step 5. Repeat steps 1 - 4 to attach the remaining three half log braces.