Instructions / Assembly

ank you for purchasing your heirloom quality furniture from Montana Woodworks®. Should you have

any questions or need to contact sales or support, please do not hesitate to contact our corporate oces at

888.889.3728 or via E-Mail at: cs@montanawoodworks.com

Tools Needed: 1/2” & 9/16” Wrench, Socket or Impact Drill, Rubber Mallet, Tape Measure, Drill & 3/16” Drill

Bit, Carpenter’s Square

Before beginning assembly, please take a few moments to carefully read the instructions, familiarize yourself

with the components and understand each step of the process. Likewise, please ensure that the hardware package

contains the items as described below.

Parts List: (1) Back Assembly, (1) Seat Assembly, (1) Right and Le Arm Assemblies, (4) 84” Swing Legs, (2) 40”

Cross Braces, (4) 26” Half Log Braces

Hardware List: (16) 4” Lag Bolts, (4) 4” Eye Bolts, (2) 6”Hex Head Bolts, (2) Hex Head Nuts, (24) Washers,

(2) Long Chains, (2) Short Chains, (8) “S” Hooks

Swing Assembly Instructions:

Step 1. Remove components from shipping boxes. You may lay the cardboard on the oor to prevent marring of

nish.

Step 2. Lay one arm assembly (“A” in the image shown on these instructions) on the oor with holes facing

upward.

Step 3. Insert the two tenons of the seat assembly “B” into the holes on the shortest part of the arm assembly.

Step 4. Insert the two tenons of the back assembly “C” into the holes on the longer, angled part of the arm

assembly.

Step 5. Repeat steps 3 and 4 above for opposite arm.

Step 6. Insert lag bolts “D” with washers “E” and eye bolts “F” into holes on outside of arms and tighten fully.

See diagram on reverse for detail.

Assembly Instructions for Lawn Swing

VIEW THE ASSEMBLY VIDEO ONLINE AT WWW.MONTANAWOODWORKS.COM

PAGE 1
Assembly Instructions for Lawn Swing Thank you for purchasing your heirloom quality furniture from Montana Woodworks®. Should you have any questions or need to contact sales or support, please do not hesitate to contact our corporate offices at 888.889.3728 or via E-Mail at: cs@montanawoodworks.
PAGE 2
Assembly of the Swing Legs: Step 1. Lay out the four frame legs (shown as “I” in the included image) and the side braces “J” into two assemblies similar to the letter A. Step 2. Insert the two tenons of side braces “J” that you positioned in step 1 above, into the holes of the frame legs “I”. Step 3. Secure each side brace “J” with a 4” lag bolt and washer combination “N” by inserting 4” lag & washer into pre-drilled hole in frame legs. Tighten halfway with a 1/2” wrench. Step 4.
PAGE 3
Hanging the Swing: Step 1. Separate the two different lengths of chain and the “S” shaped hooks. Step 2. Count eight links from the end of one long chain “G” and insert an “S” hook into the 8th link. Attach the other end of this “S” hook into the header hardware pre-mounted at the factory. Step 3. Count forty links from the opposite end of the long chain that is now hanging from the header and insert another “S” hook into the 40th link. Step 4.
PAGE 4
Glacier Country Collection Shown, Other Collections Similar