MAPZ-SS Owner Manual

Before Lighting

 Inspect the gas supply hose prior to turning on the gas. If there is evidence of a

cut, any wear or abrasion it must be replaced prior to use.

 Only the pressure regulator and gas hose assembly supplied with this appliance

should be used.

 Screw the regulator onto the gas cylinder. Leak check the hose and regulator

connections with a soap and water solution before lighting the appliance.

LP GAS CYLINDER WARNING

1. Do not store spare liquid propane cylinders under or near this appliance.

2. Never fill the cylinder beyond 80% capacity.

3. Liquid propane cylinders must be fitted with and OVERFILL PROTECTION DEVICE (OPD).

4. A 20Lb LP gas cylinder is 12.2” in diameter and 17.9” tall.

5. If the appliance is not in use, the gas must be turned off at the supply cylinder.

6. The cylinder must include a collar to protect the cylinder valve.

7. Other cylinders may be acceptable for use with the appliance provided they are

compatible with the appliance retention means and accompanied by illustrations showing

the cylinder mounted to the appliance using the cylinder retention means and the point of

contact between the cylinder and the retention means.

8. The cylinder needs to be constructed and marked in accordance with the specifications for

LP gas Cylinders of the US Department of Transportation (D.O.T) or the standards for

Cylinders, Spheres and Tube for Transportation of Dangerous Goods and Commissions,

CAN/CSA-B339 as applicable.

9. Place a dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only

install the type of dust cap on the cylinder valve outlet that is provided with the cylinder

valve. Other types of caps or plugs may result in a leak from the propane cylinder.