MAPZ-SS Owner Manual

Operating Instructions

Each burner is rated at 10,000BTU/Hr

Using the Grill

To Begin:

1. Make sure the grill has been leak tested and properly placed.

2. Remove any remaining packaging material.

3. Light the grill burner using the Lighting Instructions below.

Lighting Instructions

To Light the Burner

1. Read the instructions before lighting.

2. Make sure the control knob is in OFF position, and then turn the liquid propane cylinder valve ON by

slowly turning counterclockwise.

3. Open the front door, push and turn the burner knob to HIGH, burner should light immediately.

4. If burner doesn’t light up, turn the knob OFF, wait 5 minutes and repeat the lighting.

To Match Light the Oven

If the burner will not light after several attempts using the control knobs, the burner may be lit with a

match.

1. If you have already attempted to light the burner using the control knob, wait 5 minutes for any gas to

dissipate.

2. Insert a match into the light rod, ignite the match and insert through the pizza stone grid to the

burner.

3. Push and turn the control knob to HIGH slowly, the burner should ignite immediately.

4. If the burner does not light within seconds, turn the control knob OFF and wait 5 minutes then try

again.