Specifications

www.ripmax.com
Radio Systems & Accessories
38
Futaba Electronic Power Switches
P-FESW-1D Futaba Electronic Switch (Dual with Deans)
£32.50
P-FESW-1J Futaba Electronic Switch (Single)
£18.99
P-FESW-1J
This new electronic switch from Futaba uses FET circuitry
which enables greater current than a mechanical switch
allied to lower voltage drop. Having a voltage range of 3.7
to 8.4 volts, the switch has a continuous current limit of 5
Amps, but a short term maximum of 10 Amps for no more
than 30 seconds.
Voltage: 3.7 - 7.4V Input Voltage: 3.5 - 8.4V
Amp: 5A (10A Max, 30 sec) Dimensions: 46 x 14 x 17mm
Connectors: Futaba & Futaba
P-FESW-1D
A dual version of the new electronic switch with two output
connectors for the receiver and a Deans type connector
for the input, having a maximum continuous current limit
of 10 Amps and a 30 second limited maximum of 15 Amps.
Voltage: 3.7 - 7.4V Input Voltage: 3.5 - 8.4V
Amp: 10A (15A Max, 30sec) Dimensions: 46 x 14 x 17mm
Connectors: Futaba & Deans
P-FESW-1D
P-FESW-1J
Up to 8 non-S.Bus Servos
Part Number: P-SBC-6TERM
Part Number: P-SBD-2
£9.99
£59.99
Futaba S-Bus 6-Way Terminal Block
Futaba SBD-1 Servo Decoder Leads
Futaba SBD-2 Servo Decoder 8-Channel
P-SBD-1/200 S-Bus Servo Decoder (200mm)
£29.99
P-SBD-1/600 S-Bus Servo Decoder (600mm)
£32.50
Unit Dimensions: 30 x 40 x 16mm
Voltage: 4.8 - 7.4V
Weight: 14.2g
Lead Length: 75mm Unit Dimensions: 51 x 21 x 15mm
Weight: 9g Input Ports: 6
This clever decoder unit simply plugs into an S-Bus/S-
Bus2 port in a Futaba S-Bus receiver and it then decodes
the S-Bus signal, converting this into 8 conventional servo
outputs. The specific channels that are to be decoded can
be selected in blocks
using the rotary dial,
whilst a separate
battery can be
connected to the unit
to supply power to the
servos being used.
This genuine Futaba 6 way terminal block is a
neat and clean way to plug in multiple Futaba
S.Bus items into a single output. Moulded
from tough plastic with small lugs allowing
you to screw it down to keep it secure.
These two new decoder leads brings the total range to five,
all of which decode S-Bus signals so that conventional servos
can be used, each lead having three independent outputs.