Specifications

[e-mail]
Engines & Accessories
29
The ideal way to tidy up the potentially messy business of
getting fuel out of a container and into your model. Two
fittings go in your fuel bottle top, one is attached to the
fuel tube into the bottle with a filter on the other end which
doubles as a clunk. The other end goes to the filtered
probe on a longer length of tubing to fuel the model. The
probe plugs into the other bottle fitting when not in use.
All you need extra is suitable fuel tubing for either glow or
petrol fuels.
• Fit to any Plastic Fuel Bottle Cap
• Aluminium Machined Probes
• Brass Machined Adaptors
• O Ring Seals
• Filtered for Clean Fuel
These handy kits allow conversion of rigid fuel tanks
for use with petrol (gasoline). Normal bungs are
made of silicon, which is not compatible with petrol.
The bung supplied here is made from a durable,
advanced material that copes with both petrol and
glow fuel. The supplied length of fuel tubing is also
petrol compatible for use inside the tank on the
clunk. The brass tubing is to suit your chosen main
fuel tube bore. Available in to suit both 1/8” and
3/16” fuel tube.
£89.99
£4.99
£9.50
A super heavy-duty, geared starter for 1.60/2.00 class four strokes
and 30cc to 55cc petrol engines. Would also suit .90 to 1.30 class
helicopter engines. The large Silicone drive ‘rubber’ is designed for larger
spinners. Supplied with integral battery mount to suit a 4S 2200mAh
30C Li-po pack (O-HE4S1P220030A) which is not included. The Li-Po
battery conversion adaptor lead is supplied, as is a lead for connecting to
a 12v Lead-Acid battery if required.
This high flow rate anti-siphon check valve made
from aluminium is suitable for all RC fuel systems.
Often used with the Sullivan SkyWriter Smoke
Pump.
• Machined Aluminium Body - Long Life
• Viton Internal Seal, Compatable with all Fuel Types
• Low Cracking Pressure - Allows for Easy Priming
• Works with 3/32 Tubing - Quick and Easy
Installation
Gear Ratio: 3.5:1
Top RPM: 2,700rpm (no load)
Torque: 41 kg/cm with 12v Lead Acid
Torque: 45 kg/cm with 14.4v Li-Po
Ripmax TY1 Starter
Ming Yang Fuel Can Fitting Kit
Sullivan Aluminium Anti-Siphon Check Valve
Sullivan Petrol Tank Conversion Kits
Part Number: L-MG1020
Part Number: L-SLN756
L-SLN484 Sullivan Petrol Tank Conversion Kit 1/8” Tube
£6.25
L-SLN489 Sullivan Petrol Tank Conversion Kit 3/16” Tube
£7.50
L-RMXSA01 Ripmax TY1 Large Silicone Spinner Cup
£8.99
L-RMXST01HD Ripmax TY1 Heavy Duty Starter w/o Battery
£89.99
Aluminium
one way valve
Suits
Petrol
Diesel
& Glow
High
Power!