Operating instructions

28
Should you need to replace the plug, please read the
instructions and connect the wires as detailed below.
If in any doubt, consult a qualified electrician.
The coloured markings identifying the terminals in your
replacement plug may not correspond with the colours
of the wires in the mains lead of this appliance, so
proceed as follows:
The wire that is coloured green and yellow must be
connected to the terminal marked with the letter E,
or the earth Symbol , or coloured green or green
and yellow.
Always fit the same value of fuse as that originally
supplied with your appliance.
Only use BS 1362 approved fuses.
As a guide only:
Appliances under 700 W can have a 3 Amp. fuse (red)
and all others should have a 13 Amp. fuse (brown).
When disposing of an old plug (particularly the
moulded type that has been cut from the mains
cord) always remove the fuse as the plug could be
dangerous if ever inserted in a live socket.
When using the Monster 60 SuperClean with the
shoulder strap, avoid rocking or tilting the unit exces
-
sively as this may cause water to enter the hose and
be discharged along with the steam.
Fitting A Different Plug (UK Only)
This appliance is already fitted with a BS 1363 13
Amp. plug. The wires in the mains lead are coloured
as follows:
Green and yellow: Earth
Blue: Neutral
Brown: Live
Care & Maintenance
If you always use demineralised or distilled water,
cleaning the boiler is unnecessary.
Rinsing out the steam cleaner:
Normally, a periodic rinse of your Monster 60 Super
-
Clean will free it from deposits. This is recommended
every 10-15 tankfulls, to free up any scale deposits
from the tank.
Fill the boiler with water and shake the cleaner vi
-
gorously. Tilt the cleaner upside down to empty the
boiler of water and any scale deposits.
Descaling your steam cleaner:
If the tap water in you area contains a high level of
calcium deposits and you have been using tap water
to do your steam cleaning, your should descale your
unit after 10-15 tankfulls.
Step 1: Unplug the steam cleaner from the power
source before you descale the boiler.
Step 2: Fill the boiler with 1 part (150 ml, _ pt) vinegar
and 4 parts (600 ml, 1 pt) water and leave overnight
or for a period of approximately 8 hours. Do not
screw the safety/filler cap onto the steam cleaner
while you are descaling the boiler.
Step 3: After the period of soaking, turn the steam
cleaner upside down to empty solution from the
boiler. Due to the fact that a small amount of solution
will be left in the boiler, it is necessary to rinse the
boiler out with clean water 2 or 3 times.
Your steam cleaner is now ready for use.
Do not use the steam cleaner while descaling solu
-
tion is inside the boiler.
Attaching the Shoulder Strap
Using the detachable shoulder strap allows for
greater freedom of movement when both hands are
needed for various cleaning tasks.
To attach the shoulder strap to the steam cleaner,
simply snap the shoulder strap hooks onto the con
-
necting rings on the unit body.
See illustration below.