Operating instructions

23
Using Monster 60 SuperClean with Floor Brush
Step 1: Connect one of the extension tubes to the
steam gun on the flexible steam hose. To attach the
extension tubes one onto the other or onto the steam
gun, press the locking button ensuring that it fits into the
hole. To disconnect, repeat the operation by pressing
the locking button and pulling the two sections apart.
NOTE: Fit floor brush with the brush adaptor on to the
extension tube.
Step 2: If the brush adaptor is not attached to the
floor brush, hold the brush with its bristles up in your
left hand. With the brush adaptor pointing downward,
insert it into the hole in the back of the brush, then turn
the brush adaptor 180°.
Step 3: Insert the electrical power plug into the wall
socket. Heating time is approximately 5 minutes with
cold water. Filling the boiler with hot water will shorten
heat up time.
Attaching a Cotton Cloth to the Floor Brush
The cotton cloth provided can be fitted on this brush
so as to absorb the dirt and protect delicate surfaces.
It can also be used on vertical washable surfaces
following the same procedure as for the floor.
IMPORTANT: When using floor brush to clean tim
-
ber, parquetry, painted walls and ceilings, to avoid
scratching the surface make sure that cotton cloth is
securely attached and that none of the bristles break
through. If necessary use 2 cloths.
Fitting the cotton cloth
1. Place the brush on the cloth.
2. Fold the cloth as shown below.
3. Fold other side as shown below
4. Place the corner under the cloth holder as shown
5. Repeat for the other end of the brush head, pulling
the cloth to stretch it into place.
Operating Instruction (cont.)