Instruction manual

7
Before Use & Using Your Steam Cleaner
Before Use
3
4
Filling Steam Cleaner with Water
WARNINGS
• Carefully read all instructions before removing Boiler Cap.
• Always unplug appliance and be sure it has cooled
completely before lling the Boiler.
Connecting Extension Tube(s)
• Attach one Extension Tube to Steam Gun on Flexible Steam Hose.
• To attach Extension Tubes together, press down the locking button
while sliding Tubes together. Be sure button and hole line up and
button locks in place. To disconnect, press the locking button and
pull the two sections apart.
WARNING: Always ensure appliance is shut off and not steaming
when attaching an accessory to the unit.
Follow these instructions to avoid overlling the Boiler.
• Be sure appliance is unplugged, and has cooled for at least 10
minutes before lling with water.
• Carefully remove Boiler Cap by
turning it counterclockwise.
• Pour in a maximum of 1.2 L/2 pints
water using the provided Filler Funnel.
Make sure that
water does not overflow.
• Replace Boiler Cap by turning it clockwise.
• Plug unit into 3-prong, grounded outlet.
• Power Indicator Light will illuminate, unit will
produce steam and water tank will become
pressurized. If using cold water, heating time
is about 5 minutes. Using hot water reduces
heat time.
NOTE: Never turn on Steam Cleaner if Boiler is empty.
*IMPORTANT*
Use tap water – distilled or demineralized water if tap water is too
hard.
DO NOT add detergents, perfumes, oils or other chemical
substances.
Using Your Steam Cleaner
Max. 1.2l
For Authentic Monster Replacement Parts
Canada:
888.978.3262 US: 888-896-8786