User Guide

INSTALLATION
STEP 1
Before installing anything, try out different shapes and patterns
with your panels on the floor or a large table to decide what you
would like to create! Consult the Design Guide for ideas.
STEP 2
IMPORTANT:
• For best results, don’t disconnect the
controller from the first panel that you
already have installed.
• To ensure all panels light up, make sure
all the connectors always point the
GREEN side AWAY from the controller.
• Only one GREEN side should ever be
connected to a single panel at a time.
First, clean the mounting surface with rubbing alcohol and let dry.
When you’re ready to start, peel off the adhesive backing from
one Prism panel, place the panel on the wall over an open
GREEN connector, and press gently on the center.
examples, starter kit + 1 add-on pack:
PRESS
GENTLY
3