Specifications
1.
Set
up
at least two Monster PowerNet devices according to the
initial
setup instructions. and ensure that they are receiving power.
2.
Press and hold the
PLC
security Sync button on the
bottom
of one
PowerNet
for
approximately ten seconds
until
the Power/Security
LED
light
on
the
front
of the device flashes. Then release the button.
3.
Repeat Step 2
for
the second PowerNet device. The security key has been
erased from both PowerNet devices. They
must
now
be
re-linked to reset
a new
key.
Note:
You
have 2
minutes
to
link
PowerNet devices before they
revert
to
normal
operating mode.
4.
Press and hold the
PLC
Security Sync button
on
one PowerNet device
for
2 seconds
until
the Power/Security
LED
light
flashes.
5.
Repeat Step 4 for the
other
PowerNet device.
6.
After
a few seconds the Power
LED
flashing
will
stop, indicating they
have been linked together
with
a new
security
key.
11
'\
,
J
•
)
,
J
ADDING
MORE
POWERNETâ„¢
DEVICES
To
add a
third
(or more) PowerNet devices to a private
network:
1.
Press and hold the
PLC
Security Sync button on the
bottom
of the
new
PowerNet device
for
approximately ten seconds
until
the
Power/Security
LED
light
flashes. Release the button. The
security
password has been
erased
from
the new PowerNet device. It
must
now be
linked
to
your
network
to adopt the new
network
security
key.
2.
Again, press and hold the
PLC
Security Sync button on the
bottom
of the
new PowerNet device,
this
time
for
two seconds. The
Power/Security
LED
light
will
begin to flash.
3.
Press and hold the
PLC
security/sync button on the
bottom
of any
other
PowerNet device that is already
linked
to the
network
for
two seconds.
The Power/Security
LED
light
will
begin
to
flash.
4.
The new
PowerNet
device
will
now
automatically
link
to
the
network
using the
new
security
key. The
Power/Security
LED
light
will
stop
flashing
indicating
a
successful
link
.
SETUP
TIP
If
you
are connecting more than two Monster PowerNet devices,
or
you plan
to
link
two PowerNet devices that are in remote rooms of your home, you can
link
them together
by
plugging them into
AC
outlets that are close to each
other
or
in the same room. Link
them
following the above instructions,
then move them to the
wall
outlets where you want to use them.
12