Specifications

1.SetupatleasttwoMonsterPowerNetdevicesaccordingtotheinitial
setup instructions, and ensure that they are receiving power.
2. Press and hold the PLC security Sync button on the bottom of one
PowerNet for approximately ten seconds until the Power/Security LED
light on the front of the device flashes. Then release the button.
3. Repeat Step 2 for the second PowerNet device. The security key has been
erased from both PowerNet devices. They must now be re-linked to reset
a new key.
Note: You have 2 minutes to link PowerNet devices before they revert
to normal operating mode.
4. Press and hold the PLC Security Sync button on one PowerNet device
for 2 seconds until the Power/Security LED light flashes.
5. Repeat Step 4 for the other PowerNet device.
6. After a few seconds the Power LED flashing will stop, indicating they
have been linked together with a new security key.