Specifications

ADDING MORE POWERNET
™
DEVICES
To add a third (or more) PowerNet devices to a private network:
1. Press and hold the PLC Security Sync button on the bottom of the new
PowerNet device for approximately ten seconds until the Power/Security
LEDlightflashes.Releasethebutton.Thesecuritypasswordhasbeen
erased from the new PowerNet device. It must now be linked to your
network to adopt the new network security key.
2. Again, press and hold the PLC Security Sync button on the bottom of the
new PowerNet device, this time for two seconds. The Power/Security
LEDlightwillbegintoflash.
3. Press and hold the PLC security/sync button on the bottom of any other
PowerNet device that is already linked to the network for two seconds.
ThePower/SecurityLEDlightwillbegintoflash.
4. The new PowerNet device will now automatically link to the network
usingthenewsecuritykey.ThePower/SecurityLEDlightwillstop
flashing indicating a successful link.
SETUP TIP
If you are connecting more than two Monster
®
PowerNet devices, or you plan
to link two PowerNet devices that are in remote rooms of your home, you can
link them together by plugging them into AC outlets that are close to each
other or in the same room. Link them following the above instructions,
then move them to the wall outlets where you want to use them.
12