Specifications

1. Set up at least two Monster PowerNet devices according to the initial setup
instructions, and ensure that they are receiving power.
2. Press and hold the PLC security Sync button on the bottom of one
PowerNetforapproximatelytensecondsuntilthePower/SecurityLED
light on the front of the device flashes. Then release the button.
3. Repeat Step 2 for the second PowerNet device. The security key has been
erased from both PowerNet devices. They must now be re-linked to reset a
new key.
Note: You have 2 minutes to link PowerNet devices before they revert
to normal operating mode.
4. Press and hold the PLC Security Sync button on one PowerNet device
for2secondsuntilthePower/SecurityLEDlightflashes.
5. Repeat Step 4 for the other PowerNet device.
6.AfterafewsecondsthePowerLEDflashingwillstop,indicatingthey
have been linked together with a new security key.
11