Owner Manual

FLOOR MOUNTING INSTRUCTIONS
Items needed:
 4 hex head fasteners and washers appropriate for your floor type.
 Drill and drill bit matched to your floor material and fastener size.
 Masking/Duct tape to hold templates to floor
 Four sheets of paper for use as drilling templates
 1 pencil
 Socket wrench to tighten fasteners
Instructions: Read through all instructions before you begin
1. Place MonsterVault on floor in desired location.
2. If MV is located under bed, move bed away to expose entire Vault.
3. Slide one sheet of paper under each corner of vault leaving the edges of paper
exposed and tape each sheet securely to the floor. Take care not to change position of
vault on floor.
4. Trace corner locations of vault onto templates.
5. Remove drawer. This requires 2 people, one person on the right side and one on the
left. Open drawer fully. Locate black plastic levers on drawer slides and push left one
up and right one down to release drawer. Slide drawer out and off glides.
6. Reach into vault and trace hole locations on paper templates.
7. Remove MonsterVault. Take care not to move templates or holes will not line up
properly.
8. ENSURE THAT DRILLING HOLES WILL NOT DAMAGE OR INTERFERE WITH
ANYTHING IN FLOOR i.e. VENTS, ELECTRICAL, PLUMBING. Drill mounting holes in
floor and prepare holes for fasteners.
9. Place Monster Vault back on templates and align corner tracings.
10. Install front two fasteners but do not tighten until all four holes have been located and
all fasteners are in place. Remove templates and tighten all fasteners.
11. Pull glides out to full extension. Slide bearing trolleys out to full extension and they will
click into place. Replace drawer: This requires 2 people, one on the left side and one
on the right side. Carefully align drawer with glides so they slide back together. Push
the drawer until completely closed to reset the glides.
12. Replace bed and secure your valuable in the MonsterVault.
NOTE: Bolting/unbolting of the unit is at the consumer’s expense and discretion. Hilltop
Workshop LLC is not responsible for any associated costs or damage.
If you have any questions about mounting the safe, please check with your local home
center/hardware retailer or independent contractor.