Owner Manual

OPERATION

TO OPEN THE SAFE

1. To unlock and open safe, enter the pass code followed by “A” or “B”.

2. Turn door entry knob to the right and open door.

TO CLOSE THE SAFE

1. Close the door and hold it in the closed position.

2. Turn door entry knob to left to engage the lock bolts and lock safe.

SETUP

STEP 1. OPEN SAFE WITH OVERRIDE KEY

1. Insert override key and turn right to unlock safe.

2. Turn knob to right and open safe door.

3. Override key cover is located in bag with key.

STEP 2. INSTALL BATTERIES

1. Remove battery compartment cover(A) on

inside door by pressing on tab and pulling

off

2. Insert 4 “AA” batteries

3. Replace the battery cover.

4. Do not close drawer before testing digital

lock

STEP 3. TEST DIGITAL LOCK

1. With door open, turn knob left to put locking door bolts (B) in lock position.

2. Remove override key and store in a secure place. NEVER STORE KEY INSIDE SAFE!

3. Enter the preset pass code: “1”-“5”–“9”-“B” .

4. Turn knob to right within 5 seconds.

5. Lock bolts should recede into the unlocked position.

STEP 4. PROGRAM A NEW PASSCODE

1. With drawer open, press reset button (C)

inside door.

2. Yellow light is on, enter new pass code in

30 seconds.

3. Enter new code (3 to 8 digits) followed by

“A” or “B”.

4. Safe will beep and yellow light will turn off.

NOTE: The factory pre-set code will not work after a new pass code is programmed.