STEEL SECURITY SAFE Read this manual carefully and never store it inside the safe!
Steel Security Safe with Digital Lock PACKAGE CONTENTS 1 – Steel Security Safe 1 – Operation Manual 1 – Override Access Key Additional items needed: 4 – “AA” Batteries 4 – Fasteners for floor mounting Optional vehicle mounting kit available.
SETUP STEP 1. OPEN SAFE WITH OVERRIDE KEY Insert override key and turn right to unlock safe. Turn knob to right and open safe door. Override key cover is located in bag with key. 1. 2. 3. STEP 2. INSTALL BATTERIES A 1. Remove battery compartment cover(A) on inside door by pressing on tab and pulling off 2. Insert 4 “AA” batteries 3. Replace the battery cover. 4. Do not close drawer before testing digital lock B B STEP 3. TEST DIGITAL LOCK 1.
SECURE LOCKOUT PERIODS If a wrong code is entered three times in a row, the digital keypad will begin a five-minute secure lockout period. During this secure lockout period the keypad will become disabled. Once the lockout period has expired, the safe can be unlocked using the correct pass code. You may use the override key to open safe, but keypad will be disabled for the full lockout period.
SAFE SERIAL NUMBER Whenever contacting our Consumer Assistance Department, you will need to provide them with the serial number of your safe. The serial number tag is located on the upper right corner on the back of the safe. IMPORTANT: Do Not Remove Tags! This is needed if your safe fails or you lose your key. ORDERING NEW KEY OR REQUESTING LOGO STICKER If a key is lost or you would like additional key, you must first contact our Consumer Assistance Department to verify ownership.
FLOOR MOUNTING INSTRUCTIONS Items needed: 4 hex head fasteners and washers appropriate for your floor type. Drill and drill bit matched to your floor material and fastener size. Masking/Duct tape to hold templates to floor Four sheets of paper for use as drilling templates 1 pencil Socket wrench to tighten fasteners Instructions: Read through all instructions before you begin 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. Place MonsterVault on floor in desired location.
LIMITED CONSUMER WARRANTY Hilltop Workshop, LLC, (“HTWS, Inc.”) warrants that for a period of seven (7) years from the date of purchase, this product will be free from structural or mechanical defects resulting from materials or workmanship. HTWS, Inc., at its sole option and as the purchaser’s sole remedy under this warranty, will repair or replace this product or any component of the product found to be defective during the warranty period.
