Speaker System User's Manual

TROUBLESHOOTING GUIDE

PROBLEM - One of the speaker pairs hooked up to the Monster Multi-Speaker Selector isn't working.

Possible Cause #1

You haven't pushed the speaker selector button on the front panel of your Monster Multi-Speaker Selector

that corresponds with correct speaker terminal on the back panel. For example, if you push the Speaker 2

selector button, that will only select the speaker pair properly hooked up to the speaker terminal labelled Speaker 2.

Possible Solution

• Push the speaker selector button on the front panel of your Monster Multi-Speaker Selector that corresponds

with the correct speaker terminal on the back panel.

Possible Cause #2

You have improperly hooked up your speaker cable to the corresponding speaker terminal.

Possible Solution

• Turn on your amplifier or receiver..

Possible Cause #3

Your amplifier or receiver is not turned on

Possible Solution

• Make sure your amplifier or receiver is plugged into a properly grounded 120V wall outlet.

• In some households, a wall switch may need to be thrown to make the wall plug come alive.

Try turning on the light switches located near the wall unit powering the Amplifier or Receiver.