User guide

User Guide
3
VULKANO SETUP FOR WINDOWS 7 AND VISTA
Congratulations on buying Vulkano. We will take you through a few simple steps to get you up and
running.
These steps are for setting up your Vulkano from a Windows 7 PC or Windows Vista PC. If you are
using a Windows XP PC or a Mac, please look in the Table of Contents of this User Guide to find the
appropriate section.
CONNECT VULKANO TO YOUR SET-TOP BOX (STB)
Your STB has output connectors on the back for Component, Composite, or both. If you have both, use
Component for better video quality. (You will need a Set-Top Box to use Vulkano)
 Connect audio and video cables from the STB “Output” connectors to Vulkano’s video and audio
“Input” connectors as shown. For Component, you will use two cables. For Composite, you
will only use one
Component
Composite
 Write down your STB brand and model number. You will need it later in the Setup.
CONNECT VULKANO TO YOUR TV
This step assumes that your STB was previously connected to your TV. You will re-use your existing
cables. It is not mandatory to connect Vulkano Flow’s output to a TV.
Your TV has audio and video “Input” connectors on the back or side for Component, Composite, or both.
Make sure you use the same cable types, either Component or Composite, for this connection as used in
Step 1.