User guide

User Guide
20
wireless network, it will no longer be necessary to have your Vulkano connected directly to your
router, complete the cable connections as described in Steps 3 and 4.
1. Disconnect the Ethernet cable from your Vulkano
2. Click Next
Note: If necessary, unplug the power supply from your Vulkano and reconnect the audio and
video cables from your STB to your Vulkano. Then, reconnect the power supply. When the
Vulkano status light turns green, Click Next on the Connect to Set Top Box window.
CONNECT VULKANO TO YOUR SET-TOP BOX (STB)
Your STB has output connectors on the back for Component, Composite, or both. If you have both, use
Component for better video quality. (You will need a Set-Top Box to use Vulkano)
 Connect audio and video cables from the STB “Output” connectors to Vulkano’s video and audio
“Input” connectors as shown. For Component, you will use two cables. For Composite, you
will only use one
Component
Composite
 Write down your STB brand and model number. You will need it later in the Setup.
CONNECT VULKANO TO YOUR TV
This step assumes that your STB was previously connected to your TV. You will re-use your existing
cables. It is not mandatory to connect Vulkano Flow’s output to a TV.