User guide

User Guide
55
SETUP THE STB CONTROL
Vulkano uses the same technology found in a universal remote control to send control codes for
a wide variety of STBs. The invisible light signal is sent from the small dark window at the front
left of your Vulkano (when looking at it from the front). This signal is strong enough, in many
cases, to bounce off the walls of your room and back into your STB’s remote control detector
window (which is often behind a dark piece of plastic on the front panel).
However, sometimes there may be a problem with the light getting from your Vulkano to your
STB. If you have no luck at all in getting your STB to respond, you should use the IR Blaster cable
which came with your Vulkano kit. Insert the plug into the hole label IR Blaster, located on your
Vulkano's rear panel. The location of the IR Blaster jack depends on the model of your Vulkano
device.