User guide

User Guide
43
CONNECT VULKANO TO YOUR TV
This step assumes that your STB was previously connected to your TV. You will re-use your
existing cables. For the setup process, it is not mandatory to connect your Vulkano output to a
TV. Your TV has audio and video input connectors for Component setup, Composite setup or
both. Make sure you use the same cable types, either Component or Composite, for this
connection as used in the previous section.
Connect the cables from your Vulkano output connectors to your TV’s input connectors, as
shown below. For the Component setup option, you will use two sets of cables. For the
Composite option, you will only use one set.
If your TV has an HDMI input connector, use the HDMI setup option for better audio and video
quality.
Follow through the remaining steps in the setup wizard, or refer to the Vulkano Setup For PC
(Continued)/Select Video Input section on page 45.