User guide

User Guide

Note: Use the number keys to select the first letter. For example, 2 = A, B, C, 2. Then use the

Up/Down Arrows to choose the exact model name. If your device model is not listed, choose a

similar model number if possible.

For Use code learned with PC Setup Wizard, it will be necessary to, first, setup your Vulkano to

learn your remote control codes.

1. Select Use code learned with PC Setup Wizard

2. Press OK

For information about assigning control codes, please refer to the Learning Remote Control

Commands (For PC) on page 46, or Learning Remote Control Commands (For Mac) section on

page 54.

STB TUNING TEST

To test the remote commands:

1. Press the CH+ and CH- buttons

2. Press OK

Using the Arrow buttons on your Vulkano remote:

 Select It worked if the remote commands work

 Select It didn’t work if the remote commands

failed, and follow the instructions

 Select Try again to test the remote commands

again

 Select Continue anyway to skip the test and try

again later

 Press OK

Note: If the STB tuning test still does not work, you may need to set up your IR Blaster cable.

Please refer to the Setup The STB Control section on page 55.